Ring and Hoop Earring Forming Die Press 4 Repeating Pattern Tool. Various Designs. J2403
Description
These Ring/Hoop Forming Dies have patterns which repeats 4 times. Please note this listing is for one forming die only.
There are 3 different designs, please select the design of your choice:
Design A : Simple wave, repeats 4 times around the die
Design B : Smaller wave with a peak, repeats 4 times around the die
Design C : Double wave, one small, one larger, repeats 4 times around the die
To use simply separate the two halves of the die, place your ring/earring on the bottom half of the die making sure to centre it, replace the top half of the die and hit it hard with a brass hammer. It also comes with an outer collar to hold the two halves in place and make sure they are aligned properly.
The overall size of the die including the collar is 50mm diameter by 40mm high.
Proops Brothers have been serving this industry for over 80 years.